|Constructor and Description|
|Modifier and Type||Method and Description|
Common initialization code called by all constructors.
get, getInverted, pidWrite, set, setInverted
disable, feed, Feed, getDescription, getExpiration, isAlive, isSafetyEnabled, setExpiration, setSafetyEnabled, stopMotor
enableDeadbandElimination, free, getChannel, getPosition, getRaw, getRawBounds, getSpeed, initSendable, setBounds, setDisabled, setPeriodMultiplier, setPosition, setRaw, setSpeed, setZeroLatch
addChild, getName, getSubsystem, setName, setName, setName, setSubsystem
clone, equals, finalize, getClass, hashCode, notify, notifyAll, toString, wait, wait, wait
public SD540(int channel)
channel- The PWM channel that the SD540 is attached to. 0-9 are on-board, 10-19 are on the MXP port
protected void initSD540()
Note that the SD540 uses the following bounds for PWM values. These values should work reasonably well for most controllers, but if users experience issues such as asymmetric behavior around the deadband or inability to saturate the controller in either direction, calibration is recommended. The calibration procedure can be found in the SD540 User Manual available from Mindsensors.
- 2.05ms = full "forward" - 1.55ms = the "high end" of the deadband range - 1.50ms = center of the deadband range (off) - 1.44ms = the "low end" of the deadband range - .94ms = full "reverse"